A Permanently Joined Pair. PDF version
One
thing that is necessary when planning a model
railway, particularly where goods traffic is
predominant, is to have industries that justify the
vehicles being run.
So how can I justify this pair of mites? Easy really, a furniture factory that imports Baltic timber though Barry Docks. They will be loaded eventually (watch this space) with roughly dressed tree trunks or large baulks of timber.
These two wagons are not individually compensated, the only such vehicles I have. One reason was that modifying the kit for compensation would have been unduly complex. There is an option to build them as two individual wagons too. However, they are also permanently coupled so each acts as a bogie once a load is lashed across the bolsters.
Well, that's the theory, we shall see one day if the reality lives up to it. The kit is quite straight forward to build and the instructions are clear, the only changes I made were in fitting the bolsters (see below).
The rubbing
plates and centre support are separate etches as are
the various stanchions and end corner plates. I
discarded the white metal circular bolster centres
and turned up a couple in brass.
I also used 8BA nuts with light springs and a brass washer to hold the bolster in place rather than the heavy bolts supplied.
This picture shews how it was done, the
8BA nut is fitted in the centre hole in bolster.
Back to Top
This end view shews off the strapping and stanchions
well. The corner plates really do hold the sides
and ends together.
This shot
shews how they were joined together so as to make a
close fit that still has some "give" in it. Very
simple and uncomplicated; a piece of brass strip,
bent over at 90° on the left and then sprung with a
small cotter pin at the other. KISS - keep it short
and simple.
The springs in the 3 link couplings are going to go though, I think them unnecessary.
The
finished pair painted by Ian Hopkins. A nice little
kit that one can build in a weekend, well designed
but requires some experience of etched kit
construction so I would not recommend it for a
beginner.
There are several other kits lurking in a cupboard by this manufacturer waiting to be built and they look as well designed as this one.