An Interesting Prototype Diagram T10. PDF version
Bill
Parker's kit for the Signal Post Open (Diagram T10)
(he was the original manufacturer of these kits) comes in his usual flat pack. You will need to add
a set of 3' 1½". 8 spoked wheels. I had some in
stock, which I think were Haywood. Instructions are
well up to his usual standard.
This picture shews
all the components after having been made ready for
assembly. I find it pays to do as much work "in the
flat" as possible.
All bends were done using a "Hold and Fold" where the bend line has been heavily scribed so that a witness mark shewed through on the reverse side.
The end stanchions were fitted by twisting the tabs through about 30°. This holds them firmly without soldering, rather like the old Hornby tinplate used to be assembled.
All WEP kits are compensated so there was no need to modify anything.
The completed body ready to accept the
underframe. The body goes together easily and
produces a neat, strong, open topped, box under which the
underframe is a tight fit. The side stanchions
are fitted by turning the tabs on the side through
about 30° too before the body is assembled, so no
solder to have to clean up.
Back to Top
Two shots of the underframe shew off the simple and effective design.
There
are some nice touches too, like the way the brake
units, together with the safety straps, fit together
and the tab that folds over then fits into an etched
depression on the other side of the floor.
The only parts of the original kit not used were the buffers, as usual. I replaced them, this time with neat castings from Prestige Models.
One day, Bill will get around to including buffers that match the excellence of his design, until then we shall just have to get used to spending a bit more money to build his vehicles, not that I would object to paying a little extra for good buffers in the first place.
Here are two
shots of the completed wagon awaiting a trip to
Ian's paint shop.
Anyone who has built an etched kit should be able to put this wagon together in a relatively short space of time.
It took me about a day altogether, most of the work being in preparing the various components, filing down cusps and punching out rivets. Actual assembly is relatively quick and easy.